Over 20Km Range 5.8Ghz 2W FPV Wireless Transmitter TS582000 5.8G 2000MW 8CH Video AV Audio Sender Transmission Characteristics Output Power2000mW Operating Voltage8V-25V2S-6S Operating Current800mA(12V testing Channel 24CH Video FormatNTSC/PAL Output Voltage5V/Input VoltageJumper cap selection Antenna InterfaceSMAExternal thread internal pin Weight30g Output Voltage Two output voltages, It can supply power to 5V and wide voltage cameras, Select the output voltage through a three-point jumper pad, and check the wiring scheme drawing for operation details. 1.The jumper pad is short circuited to the two points on the right, and the output is 5V at this time. 2.The jumper pad is short circuited to the left two points, and the input voltage of the power supply is output at this time. How to set channel and power? Three schemes of actual wiring diagram Wiring scheme 1: It is suitable for micro camera with voltage of 3.3-5v and current less than 100mA. If there is no condition to verify that the camera meets the above voltage and current conditions, this wiring method is prohibited, otherwise there is a great risk of damaging the transmitter. Wiring scheme 2: It is suitable for 5-25v wide voltage camera, and this scheme is universal. Wiring scheme 3: It is suitable for the camera of scheme 2 which cannot be used when the voltage is low and scheme 1 cannot be used when the current is high, for example, a moving camera. This wiring scheme is universal and basically applicable to all cameras. The disadvantage is that the wiring is a little more complicated.