This is single outlet washer pump Windshield Cleaning. The Washer Pump is located in the bottom of the Washer this will often be low down on the car. Access to the Washer pump may be gained by partly removing the inner wheel arch of bumper trim. The Pump is push fitted into the washer . The washer pipes should be push fitted on, some may have a clip to release , if push fitted on and they are hard to remove heat up with a hair dryer and they will come off . Never let Washer pump run dry as this causes failure, also put more Windscreen washer fluid than is recommended as it is less likely to freeze. Do not put anti-freeze into washer . Always put Windscreen fluid in first then top up with Water. Item Specifications: Condition: New Manufacturer Part Number: 76846-TA0-A01, 76846-TA0-A01 Interchange Part Number: 76846TA0A01 Type:Windshield Washer Pump Fitment Type: Direct Replacement Voltage:12V Connector: 2 Pins Fit for: Accord 2008-2011 (For Japan Only) 2012 (For Japan Only) TSX 2009-2013 (For Japan Only) color: White material: plastic Package Contents: 1 x Pcs Pump 1 x Pcs Rubber Grommet Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is 1-3cm. Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-Dadangjia