Description: Brand new and high quality Feature: Main Function: When retrofitting LEDs on some motorcycles, because the power of the original halogen lamp is different from the power of the LED lamp after modification, the motorcycle will detect a power mismatch, resulting in an error, no flashing or strobe, etc. It is necessary to install an LED decoder to remove fault light alarms and other problems caused by the modification of the LED light. Main Purpose: Some vehicles will change LED lights after installation, turn signals flash quickly or do not flash at all. The newly installed LED lights will report errors and other phenomena. The addition of this product can solve the flashing of turn signals and remove the ED light fault alarm. Motorcycles are suitable. Installation Instructions: The left and right lines of the turn signals are different. If you change LED lights on the left and right sides, install one on each side. If you change lights on the left and right sides, you can only install two, but the left and right turn signals (use (a resistor) and the front right and rear right turn signals (use a resistor) must be connected to the resistor with a wire. For easy installation, it is recommended to install a resistor for each turn signal. LED Indicator Resistor only, other accessories demo in the picture is not included. Specifications: Item Type: LED Indicator Resistor Material: electronic components Size: decoder 2.8x1.5cm/1.1x0.5in, cable length: 15cm/5.9in Color: Black+Red Power: 10W Resistance: 10 Quantity: 1 Set (4pcs) Note: Transition: 1cm=10mm=0.39inch Please allow 0-1cm error due to manual measurement. make sure you do not mind before you bid. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! Package Includes: 4 x LED Indicator Resistor