Works only with 2600 consoles. Supports firmware updates, Supports button remapping Easy to use web configuration interface Almost zero latency, less than 6ms latency for and for controllers using . Compatible for /for |S/for /for U Pro/for Switch Pro/for Switch Joycon/for /for /for /for /for wireless controllers (Note:Only official for / controllers are supported.) Introduction: is a multiplayer Bluetooth controller adapter for 2600 console, an open source project based on darthcloud. It uses the popular ESP32 chip. It can support the for-original for , for Switch, for , for , for , for game console wireless controllers. Open Source Project: GitHub - darthcloud/: Multiplayer Bluetooth Controller Adapter for Retro Video Game Consoles List of Tested Bluetooth Devices:https://github.com/darthcloud///Controller-pairing-guide#1-list-of-tested-bluetooth-devices Firmware Update Guide: https://github.com/darthcloud///-BLE-Web-Config-User-Manual#5-ota-fw-update-page Button Usage: Buttons: Press button Less than 3 seconds (all LEDs solid): Stop pairing mode/all BT devices disconnected. Press button between 3 seconds and Less than 6 seconds (all LEDs blink slowly): Start pairing mode. Press button between 6 seconds and Less than 10 seconds (all LEDs flash quickly): Factory reset ESP32 to the for-original firmware that came with the device and reset configuration. Colour:Black Material:ABS Package Contents: 1 * Bluetooth wireless controller converter Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.