Small clamp, feel good.Automatic buckle lock, more powerful.Ratchet: the strength of the rod-shaped connection type.Can be adjusted by adjusting the crimp force dial control on the handle.This crimp tool can be used to crimp male and female pins into 18-28 AWG wire to create a personalized thread.Features:Small pliers, good feeling.Automatic buckle locking, more powerful.Ratchet - Force type - connecting rod structure.p>It can be adjusted by adjusting the crimping force of the control wheel.Easier operation, the pressure line faster.This crimp tool can be used to crimp male and female pins into 18-28 AWG wire to create a custom wire.Specification:< p> Condition: 100% NewColor: Blue and BlackMaterial: Ni-Cr Alloy SteelSize: (L) x (W) 190 x 150mm / 7.48" x 5.51" (approx.)How to use:1. If it's in a roll, don't cut the stems, leave them until the wire is crimped. Prepare the wire by stripping approximately 1/8" (3mm) of insulation from the end.Place the wire over the crimp pin, aligning it so that the bare end is between the inner tab set on the crimp rod, while the insulated wire sits between the outer tab set.2.If your crimp pins are too short for this method, see the bottom of these instructions for an alternative.Place the wire and crimp pin into the appropriate tooth of the tool die, ensuring the insulated end is in the wider half and the top of the tooth.The tabs should point toward the pocket on the other side of the die so that the tool bends them around the wire when closed.3. Slowly close the jaws of the tool fully until they click into place. Loosen.The tabs of a properly crimped pin should form a barrel around the lead wires and another strain relief barrel around the wire insulation.4.Alternatively, if the crimped pins are too short for this process (or otherwise on a roll), fully engage the retaining strap pin.Insert dan