DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

169,00 RON
Livrare GRATUITĂ

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Marcă: Unbranded
Vândut de:

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

  • Marcă: Unbranded

169,00 RON

Economii 120,00 RON (41%)

Preț recomandat

289,00 RON
În stoc
Livrare GRATUITĂ
Vândut de:

169,00 RON

Economii 120,00 RON (41%)

Preț recomandat

289,00 RON
În stoc
Livrare GRATUITĂ

Acceptăm următoarele metode de plată

Descriere

DSO138 Oscilloscope Digital Assembled TFT with Probe Alligator Test Clip for Arduino ARM Detection D 25-26

This kit uses ARM Cortex-M3 processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as ARM test development board. Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, With automatic, regular and one-shot modes, easy to capture the moment waveform. Comes 1Hz or 3.3V square wave test signal source. With waveform parameter digital display, including frequency, period, pulse width, duty ratio, MAX. or MIN. or AVG. or Peak- Maximum real-time sampling rate: 1Msps Accuracy: 12Bit Sample buffer depth: 1024 bytes Analog Bandwidth: 0 - 200KHz Vertical Sensitivity: 10mV or Div - 5V or Div (in 1-2-5 increments) Adjustable vertical displacement with indication Input impedance: 1MΩ Maximum input voltage: 50Vpp (1:1 probe), 400Vpp (10:1 probe) Coupling methods include DC or AC or GND Horizontal time base range: 10μs or Div - 50s or Div (in 1-2-5 increments) With automatic, conventional and single trigger modes, it is convenient to capture instantaneous waveforms Trigger with rising or falling edge Adjustable trigger level position with indication Waveform before trigger can be observed (negative delay) Waveform display can be freeze at any time (HOLD function) Comes with 1KHz or 3.3V square wave test signal source Digital display with waveform parameters, the parameters that can be displayed are: frequency, period, pulse width, duty cycle, maximum value, minimum value, average value, peak-to-peak value, RMS Save or recall the waveform, the waveform does not disappear when power off Colour:Red Material:ABS Size:18 x 12.5 x 3cm Package Contents: 1 x DSO138 DIY Digital Oscilloscope Kit 1 x Probe Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different f Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.
  • ID Fruugo: 445967718-936504096
  • EAN: 7438599604249

Livrări şi Returnări

Expediat în 2 zile

  • STANDARD: GRATUIT - Livrare între lun. 22 decembrie 2025–lun. 29 decembrie 2025 - GRATUIT

Livrare de la China.

Facem tot ce ne stă în putinţă să ne asigurăm că produsele comandate de dumneavoastră vă sunt livrate în întregime şi conform specificaţiilor. Cu toate acestea, dacă primiţi o comandă incompletă sau articole diferite de cele comandate, sau aveţi alt motiv pentru care nu sunteţi mulţumit de comandă, puteţi returna comanda sau orice produse incluse în comandă şi primiţi o rambursare completă pentru articole. Vizualizaţi întreaga politică de returnare

Detalii de conformitate a produsului

Vă rugăm să consultați informațiile de conformitate specifice acestui produs prezentate mai jos.

Următoarele informații sunt furnizate de comerciantul independent terț care vinde acest produs.

Producător:
În continuare se prezintă informațiile de contact ale producătorului produsului relevant vândut pe Fruugo.

  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei Zheshuo Technology Co., Ltd.
  • Hefei City, Anhui Province, Shushan District, Anhui Province, No. 15, South Seventh Street, South Cooperative South Road, Chemical Machinery Community, Building 1, Unit 2, 603
  • Hefei
  • CN
  • 523011
  • nacufalacan81@hotmail.com
  • 13243801962

Persoana responsabilă în UE:
În continuare se prezintă informațiile de contact ale persoanei responsabile din UE. Persoana responsabilă este operatorul economic desemnat, cu sediul în UE, care este responsabil pentru obligațiile de conformitate referitoare la produsul relevant vândut în Uniunea Europeană.

  • Jean Luc
  • In Memoria Futuri SAS
  • 3 RUE DU PAS DE LA MULE 75004 PARIS
  • Paris
  • France
  • 75004
  • infoapexchen@gmail.com
  • 33745713901