How to train for TPMS tire pressure monitor sensors? 1. Turn the ignition switch to the OFF position, then press and release the brake pedal. 2. Cycle the ignition switch from the OFF position to the run position three times, ending in the run position. 3. Press and release the brake pedal. 4. Turn the ignition switch to the OFF position. 5. Turn the ignition switch from the OFF position to the ON position three times, ending in the ON position. The horn will sound once and the TPMS indicator will flash if the training mode has been entered successfully. If equipped, the message center will display TRAIN LF tire. 6. Place the tire pressure monitor activation tool on the left front sidewall (driver's side) of the tire at the valve stem. Press and release the test button repeatedly on the TPMS tool until the horn beeps. (It may take up to 6 seconds for the tool to activate the sensor; leave the tool in place for the full 6 seconds.) The beep indicates that the body control module has recognized the TPMS sensor. 7. Within 2 minutes of the horn confirming the programming of the LF tire, place the TPMS tool on the right sidewall (passenger side) of the front tire at the valve stem and press the test button to activate the sensor. 8. Repeat step 7 for the right rear tire, followed by the left rear tire in that order. The procedure is completed after programming the last tire. When training is complete, the message center (if equipped) will display TIRE TRAINING COMPLETE. Interchange Part Number: TPMS-19, 8C2Z-1A203-A Support Models: 2007-2016 Ford F-450, F-550 Super Duty; 2007-2014 Edge; 2006-2016 Escape; 2008-2016 Expedition; 2006-2016 Explorer; 2008-2015 Taurus; 2008-2016 E-150, E-250, E-350, E-450 Econoline; 2008-2016 Fiesta; 2008-2011 Crown Victoria; 2011-2016 Transit Connect Color: White Material: Plastic Package Contents: 1 x Tire Pressure Sensor Note: If the vehicle or wheels/sensors have been stationary for more than 30 minutes, the sensors will enter "sleep mode" to conserve battery power. They can be awakened by moving the tires or rolling the vehicle before initiating communication. Note: The TPMS training procedure should be performed on one vehicle at a time in an area free of radio frequency interference and at least 3 feet away from other vehicles equipped with TPMS sensors. Note: Vehicles with different front-to-rear tire pressures, such as F-Series trucks and E-Series vans, require TPMS retraining after tire rotation. If the sensors are not properly trained, the TPMS warning light will illuminate on the instrument panel. Package includes only the items listed above; all other products are not included. Note: Lighting and display differences may cause slight variations in the color of the item shown in the picture compared to the actual product. Measurement allows an error of +/- 1-3 cm.