Description:This digital turbine flow meter has modular design, high accuracy, compact size and stable performance. Easy to replace and maintain internal components. Suitable for use with output modules, sensors and remote transmitters.Features:Modular design makes it suitable for use with output modules, sensors and remote transmitters.Compact structure, easy to install.Intuitive clear reading, high reliability, measuring accuracy is 1%.High-definition displays show both instantaneous and cumulative flow.Can be widely used to measure diesel, kerosene, gasoline, etc.Specification:Material: Aluminum alloyOperating voltage: 2.3-3.3VBattery type: 2 x AAA LRO3 batteriesConnection size: 1.5inch NPTRepetition: 0.5%Measure accuracy: 1%Maximum working pressure: 20BARFlow range: 15-120L / MinSingle count: 0.00-9999.9Total cumulative count: 0-99999Mistakes count: 0.1000-9.9999Working temperature: -10C~ +60C(14F~140F)Standby time: 1 yearApplication: Diesel, kerosene, gasolineColor: BlueWeight: 684gMalfunction and solution:The flow meter is not accurate.1. The methodof field calibration is not correct. Calibrateagain.2. The flow rate on the meter is below thelowest. Increasethe flow rate.3. The flow meter is blocked by the dry liquid.Takeout the impeller and clean it carefully and make sure the impeller turnsfreely.4. The impeller is wrapped by the sealingmaterial. Removethe meter and make sure the impeller turns freely.5. Too close to the impeller. Installproperly6. Too close to the motor or electronic noiseenvironment InstallproperlyThe reading numbers faded or blanked out.1.Batteryis exhausted or not connectedCheckthe batteries or even replace themFlow rate is normal but the meter can not count. Pressthe button of DISPLAY, the meter start.1.Field calibration is not correct.Calibrateagain.2. The impeller is blocked ordamaged. Removethe meter and make sure the impeller turns freely.3.The impeller is wrapped by the sealingmaterial. Removethe meter and make sure the impeller turns freely.Flow rate is low and the meter can not count. Pressthe button of DISPLAY, the meter start.1.The flow meter is blocked by the dry liquid. Takeout the impeller, clean it carefully and make sure the impeller turns freely.2. The flow rate on the meter is below thelowest. Increasethe flow rate.The meter can not calibrate.1.Circuit board is break down. Replacethe circuit board.2. Button is fail to press. Replacethe circuit board.Package List:1 x Turbine Flow meter