Feature:1. Double H-bridge design can drive two DC motors at the same time, single-channel 7A current2. Low heat generation, no heat sink, small size and low power consumption, very suitable for battery power supply3. Signal optocoupler isolation input, which can be directly controlled by IO port without interference4. Under-voltage protection to prevent instantaneous high current from burning down the module5. Highpower TVS and electrostatic discharge circuit, suppress transient interference pulse and static electricity, stable and reliable products, industrialgrade designSpecification:Item Type: DC Motor Driver ModuleSupply Voltage: 6.5V-27VRated Output Current: 7APeak Current: 50AControl Signal Voltage: 3-6.5VPWM Frequency Range: 0-10kHzPWM Minimum Pulse Width: 10usWorking Temperature: -25-80Length: Approx. 55mm / 2.1inWidth: Approx. 55mm / 2.1inHeight: Approx. 16mm / 0.6inMounting Hole Diameter: Approx. 3mm / 0.1in.Package List:1 x Drive ModuleNote:The power supply voltage is 6.5V‑27V. The power supply must not be connected reversely or exceed 27V, otherwise the module may be burned out. Recommended to connect a 15A fuse in series with the power input terminal