Fiber chopper is suitable for cold joint and hot melt can meet a multifunctional fiberglass cutter.The SKL-6C fiber chaser uses the 16-bit levels in a very strong blade.The SKL-6C fiber chopper has longer service life, comes with triple a attachment can bend, fiber and naked fiber cutting, automatic back knife Dia.Easy to use. You just need to cover good fibers. Then to slide, you can close all cutting work.100% brand newSKL-6C Fiber Cleaver Specification:Usable diameter of the rod fiber: 125 m.Applicable fiber core quality: single core (0.25 & 0.9mm) - 12-core, tape fiber 2.5 capped wire.Cutting length for light waveguide: 18 mm.SKL-6C Fiber Cleaver Use:1. Lift the upper lever of the fiberglass cover. Open the cover clamp of the core fiber clamp. Make sure that the scroll bar of the cutter is in the front position.2. Place the optical fiber into the groove of the core fiber clamp. Align the coating line with the scale of the correct cutting length of the optical fiber. (If the cutting length is 18 mm, align the coating line with the position of 18 mm on the shell.) Then check the clear fiber if it is straight.3. The optical fibers and fiber chips are very small and sharp. If it has penetrated into the fingers or eye, all this will cause injury. So it should be very careful during the operation. For safe operation, the user must wear the safety glasses.4. Throw the fiber chips into the special container separated from the general waste.5. The cutter installed on the machine is very sharp. Do not touch it with hands, otherwise it can injure your hands.Warning:1. When using the non-optical adjustment cutter for replacement, it may not be possible to replace and mount the cutting edge or adjust the cutting force.2. SKL-6C adopts the special milling fixing screw, and there is no need to set the height of the cutting tool, even turning the cutting.Box contents:1 x SKL-6C fiber sander.