Automatically charges the battery. The rectifier and brake circuit of this controller uses an integrated module, offering improved heat dissipation and reliability compared to traditional designs. Features a fully sealed, waterproof design with IP67 protection rating, allowing for long-term operation even in wet conditions. Note: Ensure the output voltage of the wind turbine generator matches the rated voltage of the battery. Connect wires in the following order: first connect the positive and negative terminals of the battery, then connect the three-phase output of the wind turbine. Follow instructions carefully when connecting the battery and wind turbine to the controller. Reversing polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the positive and negative terminals of the battery to the corresponding positive (red) and negative (black) battery terminals on the controller. 2. Connect the three-phase output wires of the wind turbine to the three-phase input (green wires) terminals on the controller. Specifications: - Maximum input AC voltage: AC 35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ± 0.3V / 29V ± 0.3V - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ± 0.3V / 29V ± 0.3V - Protection level: IP67 - Static power consumption: 0.008A - Maximum load power: 800W - Maximum operating wind speed: 12 m/s - Operating temperature range: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Compatible with 12V and 24V systems - Installation: Bolted - Do not reverse the positive and negative connections to prevent damage to the controller Application: Wind charge controller Color: Blue Material: Aluminum alloy Package Contents: 1 x MPPT Wind Generator Controller Note: Light reflection and differences in display screens may cause slight variations between the color shown in the image and the actual product. Measurement may vary by ±1-3cm.