LED Dimmer Switch 12V 24V Touch Control Brightness Controller for LED Strip Lights Black

Dimmer for DC 12 to 24 Volt Lighting Systems Key benefits Precise brightness control for DC lighting, letting you set the right illumination level for comfort, task work, or displays. Very low standby draw of less than 60 microamperes, minimizing battery drain when installed in batterypowered systems. Reliable performance across a wide temperature range, suitable for indoor and mobile environments. Simple DC wiring and a clear maximum load rating to prevent overload and ensure stable operation. What it does and why you need it Controls DC LED and other lowvoltage lighting by adjusting output within the DC 12 to 24 volt range. Helps reduce glare and improve visual comfort while allowing dimmingbased energy reduction in many setups. Keeps power consumption low when idle thanks to minimal standby current, making it appropriate for batterybacked applications. Performance and specifications Working voltage range: DC 12 to 24 volts. Standby current: less than 60 microamperes. Drive current: 2 amperes. Maximum load power: at 12 volts up to 36 watts; at 24 volts up to 96 watts. Wiring method: DC input and output connections. Operating temperature: minus 20 to plus 85 degrees Celsius. Product type: dimmer for lowvoltage DC lighting. Compatibility and use notes Designed for DC lighting systems that operate between 12 and 24 volts. Confirm the total load does not exceed the stated maximum for your supply voltage. Rated drive current is 2 amperes. For higher total loads, use multiple units or an appropriately rated controller. Suitable for typical LED strips, DC LED modules, singlecolor LED fixtures, and other lowvoltage DC lighting loads within the power limits. Practical applications Undercabinet and accent lighting in residential kitchens or offices using a 12 volt LED supply. Lighting control in RVs, caravans, or boats running on 12 or 24 volt battery systems where low standby current is important. Small retail displays, signage, or exhibition lighting that requires adjustable brightness without complex wiring. Installation tips Ensure the supply voltage is within the 12 to 24 volt range and that total load power stays at or below 36 watts for 12 volt systems and 96 watts for 24 volt systems. Observe correct DC polarity when wiring. If in doubt, consult a qualified electrician or installer. Allow for ambient temperature when choosing installation location so the unit operates within minus 20 to plus 85 degrees Celsius. Reliable dimming control for compact DC lighting systems where low standby consumption and clear load limits are important.