Oil Fuel Drain Pump 12v Pump

PUMP FOR DRAINING OIL FUEL 12V PUMP Characteristics: 1. Widely used in general industrial equipment. 2. It works by connecting the clamps to a 12V car battery. 3. The ideal equipment for a quick and clean oil change. 4. Simple on/off power switch, easy to use. Specifications: Rated Voltage: DC 12V. Rated power: 60W. Maximum pressure: max. 0.8MPA Maximum flow: 5L/min Pump diameter: approx. 4.8 cm / 1.89 in Length: approx. 14.5 cm / 5.7 in Outlet Pipe Size(Diameter*L): Approx. 11mm*140cm/0.43"*55" Inlet Pipe Diameter: Approx. 8mm 6mm / 0.31" 0.24" Inlet pipe length: approx. 100 cm / 39.37 in Cable length: approx. 30 cm / 11.8 inch Clip length: approx. 8cm / 3.15in Main Color: Black Application: Widely used in general industrial equipment, medical equipment, chemical equipment, shipbuilding, beverage, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zoological pipeline pressure, cleaning air cooling, coal industry and metallurgical How to use: 1. Start the car engine for a while, when the oil temperature drops to about 50 degrees, start pumping oil. 2. Connect the pump to the power supply, run it for a while and observe whether the inlet and outlet are normal. 3. Open the filler cap, remove the dipstick, push the tube into the bottom of the joint until the tube does not move; then insert the inlet tube from the oil dipstick to the end (tube to the bottom of the tank, lower concave place to completely pump out the oil); lack of oil or very slow or intermittent pumping is usually caused by loose pipes and fittings. You need to reinstall pipes and fittings. ) 4. After pumping the oil, remove the tube, then run the pump for a while, pump the remaining oil into the pumping medium, or pump water for a while until the pump head is clean. 5. If it has not been used for a long time, it may not have suction, just pour water into the pump and run the pump for a few minutes until the air is released. The package includes: 1 x oil pump Outlet pipe 1 x 11 mm 1 x 8mm inlet pipe 1 x 6mm inlet pipe 2 x clips 1. 2. If you want to connect this pump to AC power, you will need a power converter. 3. Please use when the engine is warm, the engine oil is warm and the viscosity is lower, which will make pumping easier and faster. 4. This product cannot pump corrosive liquids, strong acids and strongly alkaline liquids.